Search for the Centaurus M200 in a UK shop and two listings usually sit side by side, the mod on its own and the kit. Both quote 200 watts from two batteries, yet only one arrives with a tank and coils. For anyone moving up from a pod, that gap raises practical questions. What else has to be bought, which tank capacity is legal here, and how should the whole setup be configured so that it vapes properly from the very first draw?
Centaurus M200 mod or kit, which one to buy
The kit suits anyone who does not own an atomiser yet. It pairs the Centaurus M200 with Lost Vape's Centaurus Sub Ohm V2 tank and two UB Max coils, a 0.15 ohm and a 0.3 ohm, which is enough for direct-lung vaping without hunting for anything except batteries.
The mod alone is aimed at vapers who already own a tank, a rebuildable or a dripper with a 510 thread. In both cases the two 18650 cells are a separate purchase, because Lost Vape supplies them with neither version. If you are still weighing this format against something smaller, our guide to pod vs mod sorts the choice by the way you vape.
What each version contains
The table below compares the two listings, based on Lost Vape's product pages and the box contents published by UK retailers that stock the kit.
| Item | Mod only | Kit |
|---|---|---|
| M200 mod, 5 to 200 W | Yes | Yes |
| USB-C cable | Yes | Yes |
| Centaurus Sub Ohm V2 tank, 2 ml UK version | No | Yes |
| UB Max coils, 0.15 and 0.3 ohm | No | Yes |
| Spare glass | No | Yes |
| 18650 batteries | No | No |
Lost Vape gives the body of the Centaurus M200 as 93 x 56.7 x 26 mm and 152 g, plus or minus 5 g, without batteries. The chassis combines aluminium alloy and stainless steel.
The 2 ml tank rule for the Centaurus M200 in the UK
Lost Vape lists its Centaurus Sub Ohm V2 tank at 5 ml or 3 ml, with 2 ml for all TPD versions. Only that last version matters here, because the Tobacco and Related Products Regulations 2016 limit a tank sold in the UK to 2 ml of e-liquid. The TPD version of the tank also comes with a 2 ml spare glass, so the capacity stays the same after a breakage.
Some product listings still print the 5 ml figure, copied from the international specification sheet. Checking the capacity stated on the box itself avoids buying a tank that does not match the UK rules. The same logic applies to e-liquid, sold in 10 ml bottles when it contains nicotine, at 20 mg/ml at most.
Batteries, the first purchase alongside the Centaurus M200
A dual-battery mod is not managed like a pod with a built-in cell. Run time, power delivery and safety all depend on two cells you choose yourself, then charge either inside the mod or in a separate charger.
A matched pair of 18650 cells
The manual gives a working range of 3.0 to 4.2 volts per cell. It also explains the "Low Battery" warning, shown when voltage falls below 3.3 V before use or below 2.85 V while firing. Because both cells work together, the safe rule is two cells of the same brand and model, bought together, always charged and replaced as a pair.
A cell with a torn or scuffed wrap does not go back into the mod, even if it still works. When the cells travel outside the device, a rigid plastic case keeps them away from keys and coins.
USB-C or an external charger
The mod charges through its USB-C port at 5 volts and 2 amps according to Lost Vape, which is 10 watts at most. It is the simplest option when nothing else is to hand.
An external charger still has the edge. It charges each cell individually, often shows its voltage, and lets a second pair charge while the first is in use.
Which atomiser to fit on the Centaurus M200
The 510 thread opens the mod to most of the market, but coil resistance and atomiser width make the difference. Two families stand out, the tank with ready-made coils and the rebuildable.
The Centaurus Sub Ohm V2 tank and UB Max coils
Each UB Max coil has its own recommended range. The figures below are those Lost Vape publishes for the V2 edition of the coils.
| UB Max V2 coil | Resistance | Recommended range |
|---|---|---|
| X1 | 0.15 ohm | 80 to 100 W |
| X2 | 0.2 ohm | 60 to 80 W |
| X3 | 0.3 ohm | 40 to 60 W |
All three are built for direct-lung vaping. Starting at the bottom of the range, then climbing a few watts at a time, helps find the point where the vapour stays warm without a burnt taste.
Drippers and rebuildables in RDA DIY mode
The mod offers two modes, Normal for tanks and RDA DIY for drippers and rebuildables. According to the manual, five presses of the fire button switch between them while the output is unlocked. Several UK retailer listings also mention temperature control, which the manual does not describe, so the menu on your own unit settles that point.
Two figures from the manual help before a build. The screen shows "Short Circuit" when the atomiser reads below 0.08 ohm, and "Check Atomizer" above 5 ohms. On width, Lost Vape describes 26 mm framing, while it lists the Sub Ohm V2 tank at 26.8 or 30 mm depending on the version, so the kit tank slightly overhangs the front edge.
Setting the Centaurus M200 with the jog dial
Everything on the Centaurus M200 runs through a central dial. Lost Vape presents it as a three-in-one control that replaces the plus and minus buttons and the menu.
Rotation, fire button and lock
Turning the dial changes the wattage, and the step widens as power climbs. The manual sets it at 1 W up to 39 W, 2 W from 40 to 98 W and 5 W from 100 to 195 W, with the range looping from 5 W back to 200 W.
The centre of the dial is the fire button. Three presses lock or unlock the output, a useful habit once the right setting is found. Five LEDs around the dial show the remaining charge in steps of 20%, alongside a 0.96 inch screen.
The toggle switch and the safety cut-offs
A sliding switch on the side turns the mod on, with a one-second boot according to Lost Vape, and cuts the power completely when off. That protects against accidental firing in a bag.
The Quest chip adds three protections listed by the maker, against short circuits, weak batteries and overheating. The manual gives the details, with a shutdown when the internal board passes 85 °C, use again from 65 °C, and an automatic cut-off after 10 seconds of continuous firing.
Panels and finishes
The M200 also targets vapers who care about the object itself. Lost Vape describes face panels on both sides that change quickly, so colours can be combined freely.
The official colour list includes sober finishes such as Galaxy Black, Gunmetal Gray and Midnight Blue, next to Golden Knight. UK retailers also carry themed limited editions, whose availability varies from one shop to another.
FAQ
A few practical questions come up once the mod is on the desk. Here are short answers that go beyond the choice between mod and kit.
When was the Centaurus M200 launched?
Lost Vape announced it on 24 October 2022. The maker's blog was still featuring it in February 2026, with a post dedicated to its jog dial.
Can you vape mouth-to-lung on the M200?
Yes, with a different atomiser. The UB Max coils in the kit are designed for direct-lung vaping, but the mod goes down to 5 W and can power a tighter mouth-to-lung tank on its 510 thread.
Should the batteries come out for travel?
It is not required, since the side switch cuts the power. For a long journey, carrying the cells in a rigid case outside the mod remains the cautious option.
Does a fast charger speed up charging?
No. Lost Vape states a 5 V and 2 A input on the USB-C port, so 10 W at most. A more powerful adapter still works, but the mod does not draw more. Charge it under supervision, on a clear surface.
Which e-liquid suits the coils in the kit?
UB Max coils run at high power in direct-lung vaping, which points to a high-VG e-liquid with a low nicotine strength. Nicotine salts, sold in the UK at 20 mg/ml at most, are designed for a tight draw at low power.
Centaurus M200, the right buy for your setup
Without an atomiser, the kit remains the most coherent choice, as long as its tank is the 2 ml UK version. With equipment already at home, the mod alone is enough, give or take the slight overhang of a wide tank. Either way, plan for a matched pair of 18650 cells and use the output lock once your wattage is set. Well configured, the Centaurus M200 shows that a 200 watt mod can stay simple to run, one of the broader shifts in today's vaping hardware.
Related reading
- Pod vs mod, which vape format suits the way you vape
- Best pod vapes in 2026, our picks and the criteria behind them
- Vaping trends 2026, the devices and flavours on the rise
Independent editorial content for adults only, not a recommendation to buy. Vaping products can contain nicotine, which is a highly addictive substance. Nicotine vaping products are not for sale to anyone under 18 in the UK.
